DNP Supernova Flex Manual de instalación descargar pdf (Pagina 20)

Immediately stops current screen movement.

bottom

101 Moving to 2642

203 Screen stopped at 1034

12V-Trigger control

To operate the Supernova Flex through contact closures, a pluggable terminal block

connection is available.

The terminal block has seven positions for wires.

For contact closure operation, the five terminals on the left side of the terminal block are used.

The operation of the screen through this port is as follows:

Label Name Description

Common Common wire, shorted to others for control.



Momentarily connect to common to raise the screen

incrementally. The screen will rise as long as this contact

remains shorted to common.

Raise

Momentarily connect to common to lower the screen

incrementally. The screen will lower as long as this contact

remains shorted to common.



Lower

Momentarily connect to common to send the screen to the

preprogrammed top position. It is not necessary to continue

connecting to common after motion begins.



Top

Momentarily connect to common to send the screen to the

preprogrammed bottom position. It is not necessary to

continue connecting to common after motion begins.



Bottom

For 12-Volt trigger operation, the two terminals on the right side of the terminal block are used.

Applying 5V to 12V (AC or DC) to these two terminals will cause the screen to lower to the

bottom position; removal of the voltage will cause the screen to return to the top position.

Polarity is not important (either polarity works for DC voltage).

1 2 ... 15 16 17 18 19 20 21 22 23 24

Sin comentarios

DNP Supernova Flex Manual de instalación Pagina 20